302 gearcase???

[mercguy]

like this........

I've seen some used in D-Mod and it looked like they lasted OK, but there is another issue ... more money to be spent ... there is no water inlet on the Yamato foot. Reshape and add water inlet hole on the bullet; I have seen some competent work done on these and others that were excellent work.

this was a 102 foot (would be the same for the 302 foot) I did up, for under my 30mod Merc....

[sam]

That is one example of the excellent work. Many years from now people will wonder exactly which Yamato alky motor that came off of.

With all the work that you have done to that, what would you say it is worth now? $600 $800? $1000? $1200?

[mercguy]

That is one example of the excellent work. Many years from now people will wonder exactly which Yamato alky motor that came off of.

With all the work that you have done to that, what would you say it is worth now? $600 $800? $1000? $1200?

it was sold for $600.................or somewhere close (I cannot remember)........what is was worth and what it could sell for.........2 different animals.......

[bh/]

M55y

A Bob Dunlap conversion to a M55. They should work all day under a 44mod. Two up here run under OMC looper twins, and they hammer it harder than a four cylinder does. Bob was charging $550 for these. If u use D props at 11/16", one must bush them down to the 16mm size. Some might want more skeg to run up high under a mod.