Tweet
44 XS style block and case - std bore, stock ports.<o></o>
Stock 44 block and case
Stock 44 short block - I bought mainly to get the crank but I've never had it apart so I can't say anything about the internals.
<o> Four</o> NOS .015" over Mercury small wrist pin pistons and rings.
Four new .040" over McDaniels / Wiseco small wrist pin pistons and rings.
Four NOS small wrist pin Mercury rods.
<o>
Used all aluminum O’Brien exhaust system.
</o>
Bud Parker built short tower with saddle and clamps. I had Bud build it with both powerhead bolt patterns (55H pattern and Merc 500 pattern) so you can run 30H, 55H, or Merc 500 powerheads. It is set up for Bayer adapter plate on bottom so you can run almost any kind of lower unit by changing adapter.
Power head adapter plate and steering bar.
<o></o>
New 14:15 Yamato hatchet (horizontal split). Had the gear pinned by Larry McAfee and gears coated by Swain Tech (just as I did on the 1:1 that I have been running under my 44 for several years).
Lower unit adapter plate that Larry McAfee built for me so I could run very short hoses from the lower unit to the plate and have the water go up the water tube (stock water route).
<o></o>
Dewald 4 blade prop. Was tested on a D stock Tohatsu but not run other than that. Dewald said it would run on 14:15 44 or a 1:1 Formula E / Super E.
Four carbs: two KA17s and two KA7As.
Mag
If there's anything else you need to build motor, let me know and I'll see if I have it. I can throw it in a box and ship it too.
$4000 shipped to anywhere in the continental U.S. Will not separate.
Stock 44 block and case
Stock 44 short block - I bought mainly to get the crank but I've never had it apart so I can't say anything about the internals.
<o> Four</o> NOS .015" over Mercury small wrist pin pistons and rings.
Four new .040" over McDaniels / Wiseco small wrist pin pistons and rings.
Four NOS small wrist pin Mercury rods.
<o>
Used all aluminum O’Brien exhaust system.
</o>
Bud Parker built short tower with saddle and clamps. I had Bud build it with both powerhead bolt patterns (55H pattern and Merc 500 pattern) so you can run 30H, 55H, or Merc 500 powerheads. It is set up for Bayer adapter plate on bottom so you can run almost any kind of lower unit by changing adapter.
Power head adapter plate and steering bar.
<o></o>
New 14:15 Yamato hatchet (horizontal split). Had the gear pinned by Larry McAfee and gears coated by Swain Tech (just as I did on the 1:1 that I have been running under my 44 for several years).
Lower unit adapter plate that Larry McAfee built for me so I could run very short hoses from the lower unit to the plate and have the water go up the water tube (stock water route).
<o></o>
Dewald 4 blade prop. Was tested on a D stock Tohatsu but not run other than that. Dewald said it would run on 14:15 44 or a 1:1 Formula E / Super E.
Four carbs: two KA17s and two KA7As.
Mag
If there's anything else you need to build motor, let me know and I'll see if I have it. I can throw it in a box and ship it too.
$4000 shipped to anywhere in the continental U.S. Will not separate.
Comment