Tweet
we tested and tested the piss out of these with no problems!
and they are not 9/16" they are 16 mm
and they are not 9/16" they are 16 mm
-
-
Is any body making a pick up i can buy to mount to my cavitation plates on my yamato hatchet units need 2 ? Please advise!
what is diameter of prop shaft ? its hard to tell from your pictures !
no test like a race test :<) it was on a runabout that jeff broke
where all the torc of 1 under gears and a big D "750" mod Runabout
these new runabouts will test the SWELL outa them :<)
regards
RandyLast edited by RandY Aveline; 04-07-2013, 07:58 PM.Pure of heart : Outlaw by nature
"choice not chance determines destiny"
"the race is never quite over , the course is never quite ours"
how many years must a man pay for mistakes he did not make?
here is a link of a little bit of Randy s racing history and a tribute to the late Ken Krier to learn more click the link
http://www.boatracingfacts.com/forum...221#post107221Comment
-
Propshafts & lower units
I've been using 302 units for over 7 yrs. with no problems,have made 5 mod units,,but I started using 11/16" shafts about 4 yrs. ago before I broke a shaft.I could never figure out why people want to make the shafts smaller than the factory ones!!! mine are under 44 Mercs & 45 omc mods...The shafts I've seen broken were factory ones with the front shearpin hole filled with a pin welded in then turned down to 9/16". Pretty dumb!!! might as well just throw you prop in the water...might not hurt some else....DD:
Comment
-
well said!
When people turn them down, they are removing the case hardening!Last edited by john527; 04-11-2013, 05:51 PM.
Comment
-
john527, u got an pm for 'water pickup cavitation plate for 302 case'. regard davidComment
-
still looking for 302 lower cavitation plate with build in water pickup. will paypal money in advance. wirawira100@hotmail.com .regard davidComment
Comment