Anyone here running a Bass tower on their FE/SE

[David_L6]

Any 3 cylinder OMC drivers here running a Bass tower?

[rbengines]

Bass Center

David Cleburn runs one and so does Lee Roy Keller. Sorry Cleburn's is a Mercury.

[proprider]

Nice unit!

I run one under a 3 holer and it works very well, nice unit.
Joe

[David_L6]

David Cleburn runs one and so does Lee Roy Keller. Sorry Cleburn's is a Mercury.

Thanks Rusty. Now that you mention it I remember that Cleburn has some Bass equipment. I didn't know what Keller is using.

[hydroman6]

Most of us in the N.W. run them, and have had no problems I am aware of.

[Dave M]

I do

I run one in SEH. The only problem I had with the tower is the exhaust location I have. Dumping out the bottom as I do I had to cut out some webbing for the pipe. No real problem. Still holds up. And you can adapt other lower units to it fairly easily.

[nbranews]

Bass down housing

David if you are in the market for one I have one in my shop never been used.
It is set up for running pipes but it may be adaoptable to the exaust out the bottom. Doug Schultz

[David_L6]

Doug, I'm interested if it can be set up to exhaust through the tower and is set up for water pump.

[nbass]

Through Tower Exhaust

A couple of things you may wish to consider. We run the Tohatsu exhaust through the tower. Under the stock Tohatsu engine is an engine base that brings the exhaust to the center. If there is a similar engine base for your stock engine, chances are good that the exhaust can be easily routed through the tower. Another alternative is to route the exhaust through the side of the tower. This may require some plate and some welding. The risk is heat distortion of the tower.
Good Luck,
Neil Bass