Merc 25 H.p, Mercosil, Honing ?

[DonChicho]

CAN I BE ABLE TO HONE THE CYL´S ( MERCOSIL), USING A STANDARD " BALL HONING" ??

THANKS,
DON

[nbranews]

Boring Honing Mercosil Cylinders

Cylinder Bore and Surface Finish
Based on six years of production experience, honing is not
necessary for the Mercosil 2-cycle application with a
thermostat when TCW-3 oil is used with a regular unleaded
gasoline. Diamond boring Mercosil to a 20 microns RA max.
surface finish is sufficient. In this two-cycle application, the
thermostat insures that condensation on the bore surfaces will
not occur while the TCW-3 oil insures that oil of good film
strength is being used. The absence for the need to hone a
pattern into the bore is significant because it is the general
practice to hone a pattern into the bore to hold the lubricant.
However after 1000 hours of running the “as bored” surface,
it has the topography of a honed and etched bore.
Significantly, when the as-bored Mercosil bore is honed and
Osborn brushed, the Mercosil bore outperforms the chrome
plated bore in the 30% kerosene test and the 4-Stroke oil test.

[DonChicho]

Thanks A Lot For The Info !!!!!!!

Don:d