2003 Keylard DSH still epoxied

[crankbearing]

list updated

Keylard For Sale - 2200$$$ No hardware
44XS motor - Complete - 3750$US
1 DSH/DMH Roper - 1800$ No Hardware The one in my avatar.
1 44XS Powerhead Complete - Just broke in - No Recoil - 2000$ - .015 over new pistons, brgs, seals, gaskets, updated plates, New Flywheel ready to run.

I have a Charlie Miller Tank and bar for a 55H setup with bolts - E-mail for price.

The Runne A motor and Roper A hydro still up for grabs - fast rig.


D - Lower Unit shims (prop gear) 2.50$ Each in sizes - .030 , .010, .005, .003
44 Recoil Handle Supports - Stainless mandrel bent to spec - 40$
44 Throttle Brackets - Stainless with Block - no holddown - 50$
25 XS Throttle Brackets - Complete less the holdowns - 3 left - 75$
25XS Swivel adaptor for the Inner belden cable in throttle - 3 left - 15$

I have a Run of Belden Cable hold Down being Finished Now - These are zinc plated Mandrel Bent - They will fit, 20H Popper, 30H, 55H, 25XS, 44XS. 20$ each

All items are plus shipping all items are each unless specified.

E-mail for details.

Regards,

just wanted to update the list.

[crankbearing]

10xs

Hey Steve,

A 10XS is basically a fishing motor 9.9 or 15 vintage 87 with the black and red/grey decals . I have a raw tuner unfinished that I got from Tad, I Have been trying to get the drawings to finish it to spec with no luck, I have the drawings for the 44 and 25 tuners casting and machining drawings but not the 10. The only thing noticeably different on the cowls is there is one rubber latch that secures the bottom pan to the cowl I think it is from a V-6 light cowl as it is fairly large. I would then think that the throttle stuff is the same as the 25Xs hence the extra holes drilled in the throttle backet that line up perfect on the 10/15 blocks. this is all just mounted on a 25xs tower and lower unit. I am going to do one at some point as well as soon as i get this tuner finished. I think tad may have more not sure.

Ok on the parts You need only a throttle bracket - Flywheel - get hold of Brian Rossman. I think he has a guy now. - I guess you know longer need the restrictor. Then the pans and decals. I will check with my shop on Monday to see where we are at with the Belden Hold down clamps.

[proprider]

Hey Dave

Can you help me out with a 44xs flywheel. Never did hear back from you.

[crankbearing]

400$

Hey Joe,

Brand New in from parts unknown 400$ Us plus shipping.

Regards

[proprider]

Thanks Dave

Thanks, I sent you a email.
Joe