Tweet
in need of a side turn fin bracket for 750 R . ASAP who might have one? was told the krier would be the same chine angle.
-
-
I have one, was on my Dale Hull built runabout that Jeff Ruth ran for a few years. Here is a pic of the bracket and fin. The angle of the bracket is 30 degrees down from the horizontal if you put a protractor with the 90 degrees down along the fin mount and measured the angle from the horizontal to the chine (or that would be 30 degrees of deadrise if you measure the chine from the horizontal at the bottom). Should be very close to the Krier. The bracket is basically a triangle, that was bent from sheet and the end where the triangle meets is welded together. Not using it so you can have it cheap if it'll work for you. Can ship it out tomorrow.
Comment