Yamato C-Mod Tower

[machinedcomp]

Billet Aluminum Towerhousing

7 3/8 inches tall

Will fit Yamato 102 and 302 motors

Will accommodate transom angles from 10 - 30 degrees.

Built in kick-out and jackscrew to adjust height

This unit bolts directly thru the transom.

Included are two grooved transom clamps that the motor simply slides in or slides out for easy installation.

Also included are all necessary fastners to mount the foot and powerhead.

Liquidating inventory for new design, so take advantage of low cost of $550.00 (Shipping not included)

Please contact Lee Tietze @ 503-263-2508 from 10am to 10pm or via email @ machinedcomp@canby.com with questions.

[pro350hydro]

These towers are strong, light weight, and best of all they look Great. You will not be dissapointed. I run one my-self and would not consider going back. These towers are second to none.


Buy yours today

[Holeshot Racing]

Billet Tower's

I have two of these little baby's. One on the 350 & another on the 700. Clean strong and sharp looking. As always nothing but the best from Lee. If you have a need, step up you won't be sorry!!!

Terry

[STEVE FRENCH]

Any of these left and any pic's of "new" design?----also drilled for y-80?
could 4-cyl Merc pattern be added?

Pro-foot adapter to this avail?

Look'n for 1-under, 14tooth-straight cut? / vertical split drive-only-gears (3).......THANKS....

19P

[machinedcomp]

Mod & Pro Towers

Steve,
That post is from 2005, I don't make that design anymore. I can make a tower to fit nearly anything. Attached is a photo of my latest design, It starts as a 4" x 6" x 11" 22lb Billet of Aluminum. 4 Operations and 5 hours later, it weighs 7lbs.