Wanted **2 Blade Props**

[rob watson]

I am looking for stainless steel 2-blade propellers . 7" to 7 1/2" diameter X 13 to 15 pitch . They will be going on a Konig or Quickie 'D' lower unit . Not to concerned about shaft size I can either bore them or use shims .

[mercguy]

like this??

I am looking for stainless steel 2-blade propellers . 7" to 7 1/2" diameter X 13 to 15 pitch . They will be going on a Konig or Quickie 'D' lower unit . Not to concerned about shaft size I can either bore them or use shims .

7 1/4" x 15.................I have had this for years....... got anything to trade? Will need to be bored, as it has a 9/16 hole.......


...........maybe I should bore it to 11/16 and test it first??????

[rob watson]

prop

what r u lookn 4 in trade or $$ ? Who made the prop?

[mercguy]

what r u lookn 4 in trade or $$ ? Who made the prop?

its a reworked Michigan..................

PM or email me.............mercguy@frontier.com

PS: pitch can be relative to where people take their measurements and everyone seems to different......................you looking for 15 at the trailing edge or what?

[KG4]

I have one i will have to check the dia and pitch.It was run on the old 25ss merc.

[KG4]

If you want to test it i can send it to you and if it doesnt work send it back.If it works than we can talk about price.

[Guest]

Props

I have the following 2 blade Stainless Steel Props for sale...
#305 - 12 Pitch x 6 1/8 Dia Dall
#305 - 12 x 7 Dall
#307 - 12 1/8 x 6 1/4 Dall
#314 - 12 3/8 x 6 1/4 Pinner
#314 - 12 3/8 x 6 5/16 Hill
#320 - 12 5/8 x 6 5/16 Dall
#341 - 13 7/16 x 6 1/4 Dall
All bore for Konig Lower Units
$100.00 per Prop plus shipping
e-mail billkurps@hughes.net

[rob watson]

Thanx but there a too small

[rob watson]

Bob ; let me know what size ya came up with Thanx

[propnuts]

I think I may have a couple

Not certain of the size but I think they are close to that. I am out of the country for 2 weeks but I can check when I get back.

[jon66w]

DSR 2 and 3 blade props

E mail me with your e mail address and I'll send you my complete list of D equipment and asking price of same. All my props are in perfect running condition and I used my prop pitch gage to show pitch at three different spots on each blade. I also have the description of each prop including dia, pitch, and blade type on the spec/price list which I'm sending you. If you would like pix and the pitch gage results for any particular prop, I will then send these to you as well. Thank You, Jon K Walters
walters@plantationcable.net

[machinedcomp]

2 Blade Stainles Props

Rob I have 3 props that were formerly used in your Cal-Ore series.
2 Blade Stainless Steel, 11/16 Bore, 1/4 Shear pin. 13-14 Pitch, 6.59, 7.2, 7.28 Diameters.
If your interested 503-263-2508