Wher can I buy a 9/16 prop shaft for 302

[Tantrum]

Hi Guys can anybody tell me where I can buy a 9/16 prop shaft & have it shipped to Australia I just purchased a nice little Ron Hill prop for a 302 Yamato & didn't realize it required a 9/16 shaft (should of read add properly stupid me) so if any body can help me out it would be appreciated
Thanks Darren

[Aussie Steve]

Ric Montoya mate .

[seanp3]

Ric Montoya http://yamatoracing.net/

Mike Ward http://www.yamatoracing.co.uk/

Note sure if Lee Tietze from Machined components ships oversees or not machinedcomp@canby.com

[Aussie Steve]

Ate you running a four blade on your mod ??

[blueskyracer]

Yup , Lee or Ric can fix you up with the parts necessary or ship the unit to Ric and he will install the parts for you. Just remember the retaining nut is reverse threaded and requires a tool to remove. So the phrase Righty tighty is wrong in this case. Also take a different shaft seal

[nelson yela]

My friend Mike Ward. He sells motor parts and Yamato 302, here I sent the email and the URL of the page

mike@yamato.ndo.co.uk
http://www.yamatoracing.co.uk/

[Tantrum]

No 3 blade Ive got a 4 blade but only just started to mod the engine with a Lee Tietze pipe Hi comp head (only got 135psi Comp though I think I need 160 bot not sure how to get it) so i can't spin the 4 blader at the momet + I've put on a few Kgs which does'nt help

[seanp3]

No 3 blade Ive got a 4 blade but only just started to mod the engine with a Lee Tietze pipe Hi comp head (only got 135psi Comp though I think I need 160 bot not sure how to get it) so i can't spin the 4 blader at the momet + I've put on a few Kgs which does'nt help

135 is very good compression for a 302. I've never seen it at 160

[Tantrum]

Thanks Sean fair enough was just guessing 160 or wishing more likely