If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I think I might have one. I bought this off e-Bay a couple of years ago. It was said to be for a Hot Rod. It's about 6 1/2" dia. and I don't know the pitch. It is stamped A Kalb on the back of the hub. It does not have a shear pin slot in the back like an old Hot Rod. I have never tried it because I think the blades are too thin for a Pro motor. $125.00 and I'll pay the shipping.
I think I might have one. I bought this off e-Bay a couple of years ago. It was said to be for a Hot Rod. It's about 6 1/2" dia. and I don't know the pitch. It is stamped A Kalb on the back of the hub. It does not have a shear pin slot in the back like an old Hot Rod. I have never tried it because I think the blades are too thin for a Pro motor. $125.00 and I'll pay the shipping.
Comment