Tweet
Just a few things from the first shelf in the basement.
Email me with the numbers and I will send you photos as I still can't figure out how to make them smaller. Prices are US and shipping is extra.
Location, Guelph, Ontario, Canada. Near Toronto
1) Older Merc aluminum engine stand with steel tube legs $150
3) Mark 30 face plate with plastic emblem $75
4) Mark 58 face plate glassbeaded red plastic emblem $75
5) Mark 58 face plate maroon with red pastic emblem $75
6) Mark 58A face plate black with blue plastic emblem $75
9) Mark 20H conversion fittings for recoil and fuel fittings $100
10) two Mark 20H conversion filler blocks $
13) Dick Fickett fuel tank with cap $200
16) Merc ABC test wheel in original wraper 48-26003 B $125
17) Merc ABC test wheel in original wraper 48-26003 C $125
18) Bronze 20H flywheel nut wrench original $50
20) KG7 recoil assembly $50
21) 25XS new pistons (2) number on piston 9104-A16 on the box it says
767-9104-A19 pins, clips, needle bearings spacers rings and one black
plastic rope sheve for 25XS $200
22) 20H used large end drive shaft $125
23) 20H new large end drive shaft $225
24) Mark 30 face plate wing emblem (2) $30 each
26) Mark 30 pistons and assortment of rings $400 for the lot
717-1415A2 two
717-1182A2 one
717-1182A4 eight
no box no pin one
27) Turned down flywheels for Mark 30/55 H or Merc 500/450/400
large hole $50
28) same as 27 Large hole $50
29) same as 27 Small hole $50
33) 20H popper 16/21 very good condition raced then put away $3000
#789789 on block and 787904 on ID plate
34) 20H popper 16/21 very good condition no numbers $3000
37) New folding steering bars for 30H/55H 6061 T6 aluminum
with hardware $100
38) New kickout brackets 30/55H 6061 T6 aluminum, stainless
15 degree transom, mounts on clamps and slides up with
engine includes hardware $100
39) New aluminum fuel tanks that mount under the steering bar
on 30/55H Mercs $300
41) Yamato 302 with C size prop shaft $2200
42) Merc 30H later block balanced new or older recoil your choice.
very good condition. $3000
43) 20H gear foot small skeg 16/21 single pickup very good condition
$1200
There will be more to come but my fingers are seizing up.
Charlie
44) KG7 fishing engine restored lots new $1000
45) Mark 20 good compression no spark, good gearfoot $300
46) Mark 7 with bottom cowls fishing $200
47) Chritchfield 13 ft V bottom single seat 75 Johnson Three cleaver props
trailer. This boat has won many canadian championship races $5500
48) CSR Built by Mat Arlt in Canada Carbon fibre, kevlar, epoxie and glass. flat
turner with hardware. 200 lb driver meets requirements. $3000
E mail address blacksheep@rogers.com
Email me with the numbers and I will send you photos as I still can't figure out how to make them smaller. Prices are US and shipping is extra.
Location, Guelph, Ontario, Canada. Near Toronto
1) Older Merc aluminum engine stand with steel tube legs $150
3) Mark 30 face plate with plastic emblem $75
4) Mark 58 face plate glassbeaded red plastic emblem $75
5) Mark 58 face plate maroon with red pastic emblem $75
6) Mark 58A face plate black with blue plastic emblem $75
9) Mark 20H conversion fittings for recoil and fuel fittings $100
10) two Mark 20H conversion filler blocks $
13) Dick Fickett fuel tank with cap $200
16) Merc ABC test wheel in original wraper 48-26003 B $125
17) Merc ABC test wheel in original wraper 48-26003 C $125
18) Bronze 20H flywheel nut wrench original $50
20) KG7 recoil assembly $50
21) 25XS new pistons (2) number on piston 9104-A16 on the box it says
767-9104-A19 pins, clips, needle bearings spacers rings and one black
plastic rope sheve for 25XS $200
22) 20H used large end drive shaft $125
23) 20H new large end drive shaft $225
24) Mark 30 face plate wing emblem (2) $30 each
26) Mark 30 pistons and assortment of rings $400 for the lot
717-1415A2 two
717-1182A2 one
717-1182A4 eight
no box no pin one
27) Turned down flywheels for Mark 30/55 H or Merc 500/450/400
large hole $50
28) same as 27 Large hole $50
29) same as 27 Small hole $50
33) 20H popper 16/21 very good condition raced then put away $3000
#789789 on block and 787904 on ID plate
34) 20H popper 16/21 very good condition no numbers $3000
37) New folding steering bars for 30H/55H 6061 T6 aluminum
with hardware $100
38) New kickout brackets 30/55H 6061 T6 aluminum, stainless
15 degree transom, mounts on clamps and slides up with
engine includes hardware $100
39) New aluminum fuel tanks that mount under the steering bar
on 30/55H Mercs $300
41) Yamato 302 with C size prop shaft $2200
42) Merc 30H later block balanced new or older recoil your choice.
very good condition. $3000
43) 20H gear foot small skeg 16/21 single pickup very good condition
$1200
There will be more to come but my fingers are seizing up.
Charlie
44) KG7 fishing engine restored lots new $1000
45) Mark 20 good compression no spark, good gearfoot $300
46) Mark 7 with bottom cowls fishing $200
47) Chritchfield 13 ft V bottom single seat 75 Johnson Three cleaver props
trailer. This boat has won many canadian championship races $5500
48) CSR Built by Mat Arlt in Canada Carbon fibre, kevlar, epoxie and glass. flat
turner with hardware. 200 lb driver meets requirements. $3000
E mail address blacksheep@rogers.com
Comment