If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Anyone try one of the 7 x 14 lathes from Grizzly and others ? - seem to run $6-700 Just looking for some polishing and light turning with the odd mill job now and again ..
I have used one of these for over 15 years. Mostly AL and Brass but when needed it worked fine on steel too. It is still going strong and has never failed me.
Tweet
Comment