If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I built an ASH this spring. Brought it to Camden and flipped testing. It was a straightaway flip testing the extreme tuck-under setup. We built the boat to pack a lot of air, apparently too much. Tried some extreme designs with this boat. Have not had the boat on the water since. I will be running it in FAH at Franklin and ASH at Dayton. I just put a coat of epoxy on the bottom Friday after trimming the airtraps. We did a lot of experimental things with the bottom of this boat, so hopefully I will have it running ok next week. We'll see though, I haven't tested any A stuff all year.
Comment