Y102 Kill Switch

[Pilotpete]

Anyone out there have a diagram for the Y102 kill switch. I can't seem to find one in the archives. My motor has a 2 wire connector.

[CSR4C]

One wire to each set of points.

[Pilotpete]

Then a third wire is run from the switch back to the motor as a ground? If so where is it usually attached?
Thanks

[Tom Cronk]

Two

You only need TWO wires.One to each points,No ground
wire as per CSR4C said.Points will ground out each cyl.
Tom

[Pilotpete]

I see, you are just grounding them together thru the switch, when one set of points opens, it is grounded thru the other set of points.

Thanks for straightening that out for me!