Unconfigured Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
20ssh Props
Collapse
X
-
Not really, there is a lot more to set up than 2 prop numbers, as testing will reveal. When I was active in APBA I always shared info, good for the competition. His choice to reveal some basics.
-
Originally posted by ZUL8TR View Post
What pitch and diameter range for the Y80 have you found works
-
Originally posted by deeougee View PostThe Y80 has way more torque than the 102 and 300 series motors, its the way they develop HP, pyramid versus finger reed. That 14:16 ratio cannot be over looked, it allows you to pull an inch more of pitch. I find the Y80 way more forgiving when it comes to proping versus the C motors. Practically any prop could be the one, test everything.
What pitch and diameter range for the Y80 have you found works
Leave a comment:
-
That is a common problem! Dewald can re-drill the shear pin hole to deal with that issue. Always check for that issue before starting the engine. I learned the hard way years ago...
-
Anyone else have higher rake props too close or hitting the snout on the 80?
Leave a comment:
-
The Y80 has way more torque than the 102 and 300 series motors, it’s the way they develop HP, pyramid versus finger reed. That 14:16 ratio cannot be over looked, it allows you to pull an inch more of pitch. I find the Y80 way more forgiving when it comes to proping versus the C motors. Practically any prop could be the “one”, test everything.
Leave a comment:
-
Another piece of information are the gear ratios... Y102 and Y302 are 14:15 or .933 and the Y80 is 14:16 or .875. And the other factor is the Y102 and Y302 are 24 cubic inches and the Y80 is 20 cubic inches.
Testing, testing, testing... that is the key.
Leave a comment:
-
CSH props and 20ssh props are pretty much interchangeable and will be in the ballpark with the Model 80 at the higher height of 1/2" for 20ssh .......
I suggest you use the SORC drill guide and machine only the bottom water pick up hole to the spec we published in the rulebook. I am sure you can find a good machinist to help out...))))
Leave a comment:
-
One thing I've learned over the years...any prop is worth trying...you just never know until you try it.
As for speed...close to 65 will put you in top half of most fields.
Leave a comment:
-
Where are you living in MI? Amod wheels will be to stiff. Mark or I have something that would work for you.
12M
Leave a comment:
-
Leave a comment: