If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
David, It is my belief that it is a MK30H case that was assembled with 25SS parts. Those specific priority parts would have been: 25SS drive shaft, ball bearing, and 25SS pilot assembly. In addition, the mounting studs were different. The Mk20H units had the studs mounted approx. 1 inch deeper into the housings. All other components could be shared by MK20H, MK30H and 25SS units. The technical fee for any case that leaves here completed is $165.00. Hope that helps. R.T.
Ron, Are you interested in trading my gear case towards your technical fee for work on other gear foot assembly, if so what would it be worth to you.
Thank again for your help David
Leave a comment: